PET film is thin and easy to wrinkle
PET film is prone to generate large static electricity, which causes quality problems such as blocking, ink dots, and knife lines during printing. In addition to the conventional method of removing static electricity, strengthening the temperature and humidity control of the workshop is an effective way.
When printing, a large tension is required. The printing vacuum bag should use special inks that are resistant to high temperature cooking, and always pay attention to whether the film is static.
NY is easy to absorb moisture and deform, the tension is extremely unstable
The packaging film cannot be damaged when not printed; the environmental humidity should be tested before printing, it is best to take dehumidification measures; print immediately after opening the packaging film, and at the same time can not ignore a process-preheating, preheating temperature control at 50 ～ 80 ℃, printing equipment can be used flexibly without preheating equipment, the first color group can be used as a preheating device; the tension should be appropriately reduced during printing; after printing, it must be sealed and placed in a curing room for curing 2 ～ After 3 days, recombine as soon as possible.
The focus of control is ink
Whether printing PET or printing NY, the focus of control is ink. It mainly includes the following two aspects.
1. Adjustment of ink printing suitability. Including adjustment of viscosity and color density. Can choose to adjust the viscosity of the automatic regulator to improve work efficiency. The regulator can add solvent according to the preset value to keep the viscosity of the ink unchanged. However, the color density of the ink should never be diluted with a solvent, and it should be adjusted with a special dilution agent.
2. Strictly monitor the impact of active particles. After printing for a certain period of time, the ink will produce many active groups, these groups will combine with the chromium ions of the gravure cylinder. When these combinations appear in the shallow mesh part of the gradient version, their binding force will hinder the transfer of the ink, thus Cause blockages and flower spots. Vacuum bag manufacturers must not worry about the cost at this time, they can add an appropriate amount of CHY-1 auxiliary agent.

https://www.vacuumspacebag.net